Meaning
RF current and power measurement instruments evaluate high-frequency radio disturbance coupled onto mains and signal lines attached to electronic equipment. The absorbing clamp slides along the line under test to capture maximum radiated power transferred via common-mode currents. High-frequency ferrite rings inside the device absorb RF energy while secondary pickup loops measure the high-frequency current envelope.
Standard CISPR 16-1-3 defines the physical construction and insertion loss corrections required across the thirty to three hundred megahertz frequency range. Testing stops at the boundary where radiative field measurements in anechoic chambers supersede cable-conducted power evaluations.
Transducer Calibration
Calibration protocols establish the transfer impedance and insertion loss factors applied during automated radiated emissions testing. When calibrating an absorbing clamp, a dedicated coaxial calibration line establishes a known reference signal to determine correction factors. Systematic calibration verification prevents measurement drift from invalidating compliance reports.
Physical Placement
Automated motorized tracks position the transducer along a specified length of rigid wooden runner during test execution. Moving the absorbing clamp across a distance equal to half a wavelength at the target frequency locates standing wave voltage maxima along the cable harness.
Measurement Compliance
Final test logs record the peak disturbance values recorded across all movement positions. Operating an absorbing clamp within a shielded room ensures external ambient signals do not contaminate low-level disturbance readings. Qualification sign-off requires matching measured peak levels against regulatory emission limits.