Meaning
Periodic and random AC fluctuations superimposed on a direct current power bus quantify unwanted noise coupled through conductive supply lines. Excessive conducted ripple originates from switching regulators or rectified power supplies operating within a connected host system. Measurement occurs across specific power pins at defined load levels using standard oscilloscope or spectrum analyzer setups.
Unwanted AC voltage degrades receiver sensitivity and induces phase jitter in clock circuits.
Spectral Characterization
Frequency domain analysis isolates individual switching harmonics from broadband thermal noise across the operating voltage spectrum. Engineers characterize conducted ripple by observing root-mean-square and peak-to-peak voltage amplitudes under full load and minimum input conditions. Ground loops in the test setup must be eliminated using differential probes or coaxial termination blocks to prevent false readings.
Spectral spikes matching the switching frequency of the DC-DC converter indicate insufficient LC filter attenuation.
Filtering Mitigation
Component selection for power distribution networks directly influences the suppression of high-frequency noise currents. Mitigating conducted ripple requires adding low equivalent series resistance ceramic capacitors adjacent to module supply terminals to reduce peak noise amplitudes across target bands. Pi-network filters combining series inductors with parallel capacitance provide steep attenuation above the converter cutoff frequency.
Acceptance Threshold
Module input specifications define maximum tolerable voltage noise before functional degradation occurs. Limits for conducted ripple strictly apply at the power input terminals of the integrated assembly under full RF output power.