Meaning
Calibration methods remove the electrical influence of test fixtures from measured data to isolate the performance of a device under test. Applying 2x-thru de-embedding involves measuring a single through connection that is twice the length of the fixture lead-in. Software then splits the resulting S-parameters to create a mathematical model of the test port.
Fixture Requirement
Measurements of this 2x-thru de-embedding standard provide the reference phase and insertion loss needed for the algorithm. A physical PCB trace represents the total length of two identical launch paths connected back to back. It is manufactured on the same panel as the main circuit to ensure material consistency.
Mathematical Operation
Matrix math divides the measured through standard into two equal halves. The 2x-thru de-embedding process assumes the left and right fixtures are symmetrical. It generates a virtual error box.
Characterization Accuracy
Verification confirms that the residual error remains within acceptable limits for high speed characterization. Clean results depend on the quality of the connector launch and trace uniformity. Designers use these corrected plots to sign off on chip to module interfaces.
An inaccurate standard leads to ripples in the frequency response that mask the true behavior of the device. It is often the only way to get a clean measurement of a surface mount part.