Meaning
High-speed differential signaling paths require series capacitors to block direct current while allowing alternating current data patterns to pass. An ac coupling test evaluates the presence and continuity of these series capacitors using boundary scan cells to generate step signals and monitor the response. This verifies both correct placement and basic electrical functionality.
Signal Transmission
Standard dc boundary scan testing fails when a series capacitor is in the line because the steady-state voltage does not pass through the dielectric layer. Alternating current signaling allows pulses to transmit through the capacitor, which can then be detected by the receiving node on the other side of the capacitive barrier. Pulses that fail to arrive indicate a broken line or a missing component.
Measurement Method
The test uses a transmitter cell to drive a transition, generating a transient current that flows through the capacitor and creates a voltage swing at the receiver. A fast receiver latch on the target device captures the voltage swing within a specific window.
Interface Integrity
High-speed transceiver circuits require careful verification of these interfaces prior to final board assembly. Solder voids or misaligned capacitors disrupt the high-frequency return path and cause signal degradation. Performing this check identifies assembly issues before they affect system-level validation.