Meaning
Engineering procurement specifications for gold electroplating in electronic assemblies rely on standardized material definitions to ensure contact reliability. Compliance with ASTM B488 establishes purity and thickness requirements for gold deposits applied to printed circuit boards, RF connectors and separable contacts. The standard defines four gold purity grades ranging from mass fraction ninety-nine point seven percent down to ninety-nine point zero percent, alongside three hardness codes.
Design specifications reference these classifications to prevent contact wear, fretting corrosion and high contact resistance in high-reliability interconnects.
Deposit Classification
Purity and hardener composition select the mechanical properties of the electroplated gold layer. Soft gold deposits without cobalt or nickel additives suit wire bonding and high-temperature applications. Hard gold formulations containing small additions of transition metals resist mechanical wear in repeated mating cycles.
Quality Verification
Laboratory testing specified by the standard validates deposit thickness, adhesion and freedom from porosity. Nitric acid vapor testing and cross-sectional optical microscopy verify coating integrity on critical contact surfaces. Plating thickness classes range from zero point two five micrometers for light-duty contacts up to five micrometers for severe wear environments.
Adhesion testing via heat treatment or tape test ensures the electrodeposited layer remains bonded during thermal cycling.
Interface Requirement
Substrate preparation directly influences the performance of electrodeposited gold coatings. An intermediate nickel underplate prevents base metal diffusion from copper substrates into the outer gold layer. Diffusion of copper through gold forms resistive oxide surface films that ruin electrical contact performance over time.
Standard requirements mandate minimum nickel underplate thickness to block intermetallic compound formation and preserve low contact resistance.