Meaning
Wireless communication architectures place multiple radio transmitters and receivers in close physical proximity on a single platform. When co-located transceivers operate simultaneously, the transmitter of one system can overload the receiver of the other. This scenario occurs in multi-radio gateways that run Wi-Fi and Bluetooth on the same assembly.
Shielding and filtering are necessary to maintain target sensitivity. Without proper isolation, the high-power transmit signal bypasses the antenna pathways to coupling directly into the adjacent receiver’s low-noise amplifier.
Interference Mechanism
High-power signals from a nearby transmitter saturate the input stage of the receiver to cause desensitization. This effect occurs even when the operating frequencies of the co-located transceivers are widely separated. Out-of-band emissions and phase noise from the transmitter fall directly into the receiver band to raise the noise floor.
Designers use bandpass filters to suppress these emissions. Solid board-level shielding prevents direct radiation from bypass paths.
Mitigation Strategy
Physical separation of the antennas represents the primary method to reduce coupling. In small IoT devices, this distance is often too short to provide sufficient isolation. Designers then use time-domain multiplexing to ensure that the co-located transceivers do not transmit and receive at the same time.
This approach prevents receiver overload at the cost of aggregate throughput.
Integration Testing
Verification of co-existence involves measuring the receiver sensitivity while the adjacent transmitter operates at maximum power. Test setups use directional couplers and attenuators to monitor the coupling between the antenna ports. The certification of the multi-radio system requires passing these tests under all worst-case temperature conditions.
Successful validation ensures reliable data rates in the final product.