Meaning
System verification procedures evaluate the resilience and recovery behavior of safety-critical designs under simulated failure conditions. Executing fault injection testing allows engineers to insert controlled disturbances into circuit lines or register values to observe the resulting system response. This approach determines whether the built-in diagnostic routines can isolate anomalies before they propagate.
Verification Methodology
Deliberate error introduction uses specialized software triggers or physical pins to disrupt normal logic states. The methodology targets specific safety requirements, verifying that the diagnostic coverages meet the necessary compliance levels. Automated test suites execute these scenarios.
Hardware Emulation
Hardware platforms utilize scan chains or laser pulses to change memory contents or gate states during active operation. This physical disruption tests the limits of the integrated safety mechanisms. Low-level recovery loops are verified.
Diagnostic Outcome
The primary output of these verification sessions is a detailed error-handling log that registers the time elapsed between fault occurrence and system mitigation. Developers analyze this log to identify latent design flaws, such as unhandled exceptions or cascading failures that could disable the device. If the target system fails to return to a safe state, the hardware design is adjusted to add redundant signal paths or watchdog timers.
These modifications undergo the same verification sequence to confirm that the changes have restored the necessary fault tolerance.