Meaning
Orifice length measured along the melt flow direction defines the restrictive transition between a delivery runner and the mold cavity. Maintaining an exact gate land length regulates localized shear heating, pressure drops, and freeze-off timing during plastic or feedstock injection. The dimension stops at the cavity wall where flow enters the part volume.
Toolmakers measure this boundary in millimeters or fractions of a millimeter to control flow rate without generating excessive thermal stress.
Flow Restriction
Pressure requirements jump sharply when the melt path extends through a long transition zone. Controlling the gate land establishes flow velocity and prevents premature solidification before the pack phase concludes. A land that extends too far induces thermal degradation through excessive shear heating.
Conversely, an excessively short boundary weakens the mold steel, causing steel breakout or premature fatigue chipping under repeated packing pressure.
Cavity Pack
Packing pressure sustains density throughout the freezing phase to prevent sink marks and internal voids in molded electronics housings. Proper gate land geometry preserves a molten core long enough to pack volumetric shrinkage, then freezes cleanly to isolate the runner system. When freeze-off occurs prematurely, backflow or underpacking warps the component.
Post-fill analysis relies on balanced land dimensions across multiple impressions to guarantee uniform cavity pressures.
Tool Machining
Fabricating tight transition features requires accurate wire electrical discharge machining or micro-milling setups. Dimensional checks across the gate land confirm that toolmakers met tolerances within plus or minus five microns on critical modular inserts. Subsequent wear inspections target this restriction because abrasive feedstocks round off the sharp inlet edge over extended production cycles.
Final tool approval documents record initial land dimensions to gauge ongoing erosion drift.