Meaning
Signal distortion occurs in radio frequency and power transmission systems when non-linear components generate integer multiples of the fundamental operating frequency. This process, representing harmonic degradation, reduces the purity of the transmitted waveform. It occurs when signals pass through active devices like amplifiers, mixers, or saturated magnetic components.
Physical Mechanism
High-frequency electronic circuits often operate near their limits where amplifiers begin to compress and clip the signal peaks. This non-linear behavior creates unwanted output frequencies at twice, thrice, or more times the carrier frequency. These harmonic frequencies travel along the signal lines and can radiate through the antenna or couple into nearby copper traces.
Performance Penalty
Wireless transmitters suffer from reduced efficiency when power is wasted on these unwanted frequencies instead of the primary carrier. This distortion degrades the modulation quality and increases the bit error rate of the receiver. In addition, the generated signals violate regulatory limits by leaking into adjacent communication bands and causing interference.
Protection Method
Bandpass filters and low-pass filters are placed at the output of the transmitter stage to suppress these unwanted frequencies before they reach the antenna. These filters provide high attenuation at higher frequencies while allowing the fundamental signal to pass with minimal loss. In addition, designers run simulations to ensure that transistors operate within their linear region, preventing the generation of these distortions during high-power operations.
Shielded enclosures are also used to prevent the harmonics from radiating directly from the circuit traces.