Meaning
Spurious emission measurements quantify the absolute electromagnetic energy emitted by an integrated wireless assembly at integer multiples of its fundamental carrier frequency. Radiated through antenna components, enclosure seams or printed circuit board ground planes, harmonic radiated power evaluates non-linear distortions generated primarily by power amplifiers, mixers and switching regulators. The measurement boundary applies across the far-field propagation zone up to the tenth harmonic or forty gigahertz, ceasing to govern conducted emissions measured directly into a continuous coaxial load.
Generation Mechanics
Solid-state transmitters produce unwanted frequency components when strong carrier signals force active semiconductor junctions beyond their strictly linear operating regions. The resulting non-linear response folds energy into multiples of the fundamental channel, converting legitimate drive energy into unwanted second, third and higher harmonic radiated power. In an integrated transceiver design, these harmonic frequencies present shorter wavelengths that easily excite internal metallic enclosures, flexible printed circuits or battery wiring harnesses as unintended patch or dipole radiators.
Ground discontinuities underneath high-speed radio traces further accelerate mode conversion, pushing common-mode currents directly onto the outer surfaces of metallic shielding cans.
Measurement Technique
Quantifying these spurious emissions requires an accredited semi-anechoic or fully anechoic chamber equipped with calibrated broadband horn antennas and high-dynamic-range spectrum analyzers. Engineers position the device under test on a non-conductive turntable, rotating the assembly across 360 degrees while scanning the receive antenna between one and four meters in height to locate the peak field intensity. The raw electric field strength recorded in decibels microvolt per meter is subsequently converted into an equivalent radiated power using the standardized substitution method, where an aligned dipole or horn replaces the unit to calibrate systemic propagation losses.
High-pass or notch filters attenuate the fundamental carrier at the receiver input, preventing the analyzer front end from generating internal non-linear distortion that could corrupt the harmonic reading.
Mitigation Topology
Suppressing elevated harmonic levels requires coordinated physical filtering and electromagnetic shielding across the entire mechanical stackup. Engineers place low-pass or bandpass ladder filters between the output matching network of the amplifier and the antenna feedline to attenuate high-frequency harmonics before energy reaches the radiator. Adding conductive elastomer gaskets along enclosure seams prevents high-frequency harmonic leakage through mechanical housing tolerances.
The official test report submitted for product qualification records the final harmonic radiated power levels, proving the product remains below regulatory noise thresholds before commercial distribution is authorized.