Meaning
Proportional scaling coefficients applied to tooling designs compensate for the reduction in size that occurs as a metal cools from its solidification point to room temperature. Linear shrinkage factor represents the percentage change in length per unit dimension for a given alloy. Patternmakers use this ratio to construct oversized tooling so that the cold cast part achieves the target dimensions.
Dimensional Adjustment
Different metals shrink at different rates, with steel exhibiting a higher rate of contraction than cast iron or aluminium. A typical value for cast steel is approximately two percent, while grey iron shrinks by roughly one percent. The application of this factor must be uniform across the primary linear axes of the part.
If the designer fails to apply the correct factor, the machined surfaces of the cast housing may lack the necessary material thickness to clean up during the subsequent milling operations.
Process Variable
Mold constraints can alter the actual shrinkage experienced by the casting. In open areas of the mould, the metal contracts freely and follows the nominal contraction rate. Where complex geometry restricts movement, the actual contraction may be less than the theoretical factor.
Measurement Protocol
Foundries establish this value by casting test bars of known length in standard moulds. After the test bars cool, high-precision calipers measure the final length to calculate the exact percentage of contraction. This empirical value is then saved in the pattern database to guide future tooling designs.