Meaning
Amplifier transfer functions deviate from linear behavior when input signals exceed a certain power threshold. The LNA gain compression represents the reduction in amplifier gain that occurs when a high-power out-of-band signal drives the receiver front-end into saturation. In integrated wireless products, this effect often occurs due to nearby transmitters operating on the same board.
This behavior degrades the receiver’s ability to recover weak incoming signals. The onset of this phenomenon is quantified by the one-decibel compression point.
Receiver Impact
When a receiver suffers from LNA gain compression, the signal-to-noise ratio decreases and the bit error rate rises. This degradation occurs because the saturated amplifier can no longer provide linear gain for the weak desired signal. Additionally, high-power interferers cause intermodulation distortion that falls directly into the channel of interest.
This distortion can completely block communications in multi-radio environments. System-level filtering is required to protect the receiver from these strong unwanted signals, ensuring that the module operates reliably even in the presence of strong co-located transmitters.
Filter Selection
High-rejection bandpass filters placed before the amplifier prevent out-of-band signals from causing saturation. The filter must feature low insertion loss to avoid raising the system noise floor. In dense assemblies, this represents a trade-off between receiver sensitivity and blocker immunity.
The filter must also fit the tight board space and thermal envelope of the product.
Verification Protocol
Laboratories measure this performance parameter by applying a dual-tone test using signal generators and a spectrum analyzer. The input power of the blocking signal is swept to find the point where the gain drops by one decibel. This test is conducted during the hardware qualification phase to ensure the system survives real-world interference.
Pass criteria are aligned with carrier requirements.