Meaning
Data transfer in flash memory occurs by writing information into a specific sector known as a page rather than the whole block. This process, termed page programming, applies high voltage pulses to the selected memory cells to alter their threshold voltages to represent binary data. Because flash cells can only be transitioned from a high state to a low state during this operation, the page must be erased before it can be rewritten.
Technical Execution
Memory controllers manage the timing and sequence of voltages applied to the word lines during the operation to avoid disturbing adjacent cells. This task is critical because page programming can introduce errors in neighboring rows if the write cycles are too frequent or poorly controlled. Modern controller chips use error correction codes to detect and correct these disturb effects during subsequent read operations.
The controller also implements wear leveling to distribute these high-stress operations evenly across the silicon die.
Latency Constraint
Writing data to the flash array takes significantly longer than reading it or transferring it over the physical interface. This latency can temporarily block other operations.
Write Endurance
Each cycle of voltage stress gradually degrades the thin oxide layer of the memory cells. This wear limits the total number of times the memory can be updated.