Meaning
Operational standards covering intentional radiators define the technical criteria for systems utilizing frequency hopping, direct sequence, and digital modulation techniques within license-free spectrum. The regulatory framework codified in part 15.247 governs widespread commercial wireless standards operating across the 902 to 928 megahertz, 2400 to 2483.5 megahertz, and 5725 to 5850 megahertz industrial, scientific, and medical bands. The rule fixes conducted output limits, minimum channel separation rules, spectral power densities, and out-of-band emissions to permit dense spectrum sharing without destructive cross-talk.
Equipment authorizations for modern commercial products, including Bluetooth and Wi-Fi transceivers, rely directly on this technical baseline.
Power Allocations
Maximum peak conducted output power under this standard is legally capped at one watt for systems employing digital modulation or qualifying hopping topologies. The specification imposes a corresponding maximum antenna gain of six isotropic decibels, mandating a decibel-for-decibel reduction in transmitter power if high-gain arrays are attached. Fixed point-to-point links represent the sole exception, allowing directional configurations without standard power reductions on specific microwave channels.
Power density measurements mandate spreading output energy evenly, forbidding concentrations greater than eight decibel-milliwatts within any three-kilohertz measurement bandwidth. This spectral spreading prevents narrow-band interference spikes from blinding adjacent receiver architectures.
Hopping Parameters
Frequency hopping spread spectrum hardware must exhibit pseudorandom channel selection across a sequence of non-overlapping carrier frequencies. Systems deploying narrow hopping channels must utilize at least fifty channels in sub-gigahertz allocations and at least fifteen hopping channels within the 2.4 gigahertz band. The average time of occupancy on any channel cannot exceed four-tenths of a second within a period proportional to the total number of channels deployed.
Channel spacing must equal either twenty-five kilohertz or the twenty-decibel bandwidth of the hopping channel, whichever is greater. These rules guarantee that rapid channel shifts clear spectrum access continuously for co-located wireless nodes.
Band Edge Compliance
Out-of-band attenuation rules require suppression of all spurious outputs generated outside the active operational band. Any emission situated outside the defined frequency boundaries must show an attenuation level of at least twenty decibels below the highest fundamental in-band carrier power. When an emission falls within an adjacent restricted corridor, the baseline radiated limits take precedence, forcing deeper rejection filter slopes.
RF design teams configure band-pass filter architectures specifically to manage rapid roll-off near lower and upper operating margins. Failure to manage carrier non-linearities at the perimeter triggers out-of-band compliance rejections.