Meaning
Dimensional specifications in PCB stackup manufacturing drawings define the final vertical height of cured dielectric and copper layers after thermal lamination. The pressed thickness dictates mechanical fit inside tight module enclosures and governs trace impedance calculations for RF transmission lines. Multi-layer board fabricators adjust prepreg ply counts and resin content to hit targeted pressed thickness dimensions within specified manufacturing tolerances.
This parameter applies to cured multi-layer stackup geometries, ending where external solder mask coatings and surface finish platings add non-structural vertical dimensions.
Impedance Calculation
Deviations from target pressed thickness alter the distance between signal traces and reference ground planes, shifting controlled impedance away from design specifications. A ten percent decrease in dielectric separation causes trace impedance to drop below nominal system targets. Fabricators measure cross-sectioned coupon samples after lamination to confirm that pressed thickness meets signal integrity design rules.
Mechanical Enclosure
System assembly issues arise when total board height exceeds enclosure slot dimensions or connector mating tolerances. Precise pressed thickness control ensures consistent spring pin contact pressure in shield cans and housing interfaces.
Tolerance Accumulation
Combining multiple prepreg layers introduces variability across panel surface areas. Statistical process control monitors press hydraulic force and thermal ramp rates to keep height variance minimal.