Meaning
Electromagnetic field leakage originates from physical gaps between mating surfaces of conductive enclosures or board-level shielding cans. Interference control specialists analyze seam radiation to identify aperture paths that compromise device electromagnetic compatibility compliance. The leakage intensity depends on seam length, surface contact impedance, and signal wavelength relative to gap dimensions.
Analysis assumes uniform boundary contact, which fails when mechanical housing warping or thermal expansion distorts the joint profile.
Gap Impedance
Poor mechanical contact between enclosure panels creates a high-impedance path for induced surface currents. Surface oxidation, thin plating, or uneven clamping force disrupts continuous grounding, turning small mechanical slits into effective slot antennas. Maintaining low surface contact resistance along the full seam length suppresses radiated field escape.
Fastener Spacing
Screw pitch along metallic enclosure flanges governs maximum slot length between contact points. Spacing fasteners farther apart allows housing flexing under mechanical load, which widens structural gaps. Placing screws at intervals shorter than one-tenth of the highest operating frequency keeps radiated emissions below regulatory thresholds.
When mechanical constraints force wider fastener spacing, conductive gaskets fill intermediate gaps to maintain electrical continuity.
Field Leakage
Radiated energy escaping through housing seams couples into nearby antennas or external cables. Uncontrolled emissions degrade receiver sensitivity and risk regulatory compliance test failures during final product verification.