Meaning
A performance degradation state where a bus master receives fewer consecutive data cycles than required for efficient operation. This burst-length starvation occurs when the interconnect or memory controller truncates a requested transfer to service a higher-priority request. Efficiency drops because the overhead of the address phase is distributed over a smaller amount of payload data.
Transaction Efficiency
Memory controllers typically optimize for long sequential transfers to maximize the available bandwidth. When burst-length starvation occurs, the system forces small and fragmented packets onto the internal interconnect. These small packets increase the total number of cycles spent on arbitration and synchronization.
The effective data rate seen by the peripheral falls well below the theoretical peak of the bus.
Priority Impact
Dynamic arbitration algorithms allocate bus cycles based on the urgency of the requesting module. A low-priority module suffers from burst-length starvation when a high-priority video stream or radio interface dominates the available time. This results in the low-priority task taking longer to complete because it must perform more individual transactions to move the same volume of data.
Each interruption requires a full re-arbitration sequence before the next data segment can move.
Data Buffer
Maintaining a steady flow of information requires local storage at the device interface to hide the effects of bus latency. A device experiencing burst-length starvation cannot fill its internal storage at the intended rate. This leads to underflow conditions in timing-sensitive components like audio or display controllers.
Designers mitigate this by adjusting the minimum burst size guaranteed to every master on the bus.