Meaning
RF interference generation occurs when multiple signals mix in non-linear elements of a wireless device. In a smart device housing both co-located transmitters and receivers, cellular band intermodulation represents the creation of unwanted spurious signals that fall directly into active receiving channels. These spurious products arise from non-linear junctions in the antenna path or front-end components.
Spectral Impact
Degradation of receiver sensitivity happens when these generated mixing products sit within the operating band of the co-located antenna. If the transmit frequency offsets are close to each other, the resulting third-order products fall straight into the local receiver band. This raises the noise floor, which blinds the receiver to weak incoming signals.
High-order products can also fall into global navigation satellite bands or wireless local area network bands, making multi-radio co-existence difficult without high isolation. A dual-carrier test setup is usually required to verify this behavior across the entire bandwidth.
Mitigation Scheme
Component selection and physical board separation help control these non-linear mixers. Developers select passive components with low passive intermodulation ratings and place antennas far enough apart to reduce signal coupling. High-rejection bandpass filters are placed in the transmit paths to suppress the offending carrier frequencies before they reach non-linear components.
Metal shielding cans are applied to prevent radiated signals from mixing directly on the board trace junctions.
Compliance Metric
Certification testing measures these unwanted emissions during simultaneous transmit operations. The limits are typically dictated by regulatory bodies and carrier acceptance standards which demand that spurious emissions remain below specified decibel levels. Failure during these sweeps requires a redesign of either the filter network or the physical antenna placement.
Correctly managing this behavior ensures the finished product meets both operator performance standards and regulatory emission requirements.