Meaning
Bend-induced mechanical deformation occurs when flexible radio frequency interconnects experience repetitive motion or tight routing inside an enclosure. Internal center conductors, dielectrics, filler materials, and outer braided shields undergo mechanical stress during dynamic routing or board assembly maintenance. Coaxial cable flexure alters the physical geometry of transmission lines, shifting localized characteristic impedance away from nominal design values.
Structural deformation introduces phase instability and insertion loss variations across high-frequency RF signal paths. The physical scope extends from the connector strain relief boot down to the fixed solder joints on printed circuit boards. It terminates at the boundary where rigid transmission structures or stationary wave-guides absorb mechanical loading.
Bend Fatigue
Repeated movement causes work hardening within copper center conductors and metallic braid shields. Small displacement angles applied continuously across thousands of cycles degrade the structural continuity of outer conductors. Coaxial cable flexure accelerates foil cracking and braid strand snapping near rigid termination points, which creates localized impedance discontinuities.
Passive intermodulation rises as fractured shield strands make intermittent contact under physical movement. Disruption of signal paths becomes evident during automated vibration testing or field service deployment. High-flex test sequences isolate these fatigue mechanisms before product release.
Shield Integrity
Electromagnetic shielding effectiveness depends directly on the physical coverage of outer conductor braids during mechanical movement. When internal interconnects experience movement, shield strands open small gaps that allow radio frequency energy to leak into sensitive adjacent circuits. Coaxial cable flexure decreases shielding attenuation, increasing susceptibility to external noise sources and transmitter spurious emission coupling.
RF leakage degrades receiver sensitivity figures in multi-radio smart devices. Verification requires radiated emission measurements while the internal cabling undergoes mechanical bending cycles.
Qualification Limit
Factory assembly criteria specify minimum dynamic bend radii to prevent permanent mechanical damage. Exceeding recommended bending limits during enclosure assembly invalidates supplier component guarantees and shortens operational lifespan. Coaxial cable flexure must remain within defined geometric tolerances during routine maintenance and factory routing operations.
Compliance is confirmed through post-flexure S-parameter testing in quality control handovers.