Meaning
Electromagnetic emission from a cable or printed circuit board trace that occurs when unwanted currents flow in the same direction on parallel conductors represents a major source of electromagnetic interference. This emission, known as common mode radiation, is generated when asymmetric voltages excite the external shield or the reference ground plane of an assembly. It differs from differential mode emissions where current flows in opposite directions.
The resulting field can easily exceed statutory limits if not properly suppressed.
Excitation Mechanism
Unbalanced circuit paths or asymmetric component placement on a printed circuit board create voltage drops on the ground return path. This voltage drives currents along attached external cables, which then behave like monopole antennas. Cable shields must be terminated correctly to prevent these currents from reaching the outer surface.
Proper shielding prevents the cables from radiating. In many digital designs, the cable behaves as an efficient radiator of high-frequency noise generated by internal clock signals.
Suppression Technique
Engineers use common mode chokes, decoupling capacitors, and symmetrical routing to mitigate the emission. These components force the currents to cancel each other or provide a low-impedance path back to the source. A high-frequency choke increases the impedance for common mode currents while leaving differential signals unaffected.
Regulatory Compliance
Compliance testing in an anechoic chamber measures the radiated emissions from the equipment under test across a specified frequency range. Because common mode radiation is highly efficient at radio frequencies, even microampere-level currents can cause test failures. The design must be validated during the early prototyping phase to avoid costly redesigns.
Certification depends on keeping these emissions below the legal threshold.