Meaning
Nonlinear interaction between two signals in a shared transmission medium results in the transfer of modulation from one carrier to another. This cross-modulation phenomenon occurs when the amplitude variation of a strong signal causes a corresponding change in the gain of an amplifier or the properties of a mixer. It affects the reception of a weaker desired signal by superimposing the information of the interfering signal onto it.
The boundary of this effect is defined by the third-order intercept point of the system components.
Distortion Root
The presence of nonlinearities in active components like transistors and diodes is the primary source of the problem. If a 7/16 din interface or a similar passive component develops oxidation, it can also induce cross-modulation through the diode effect. This transfer happens most often in multi-channel systems.
Signal purity suffers when gain saturation occurs.
System Sensitivity
Receiver performance is compromised when the unwanted modulation exceeds the noise floor of the intended channel. While cross-modulation is distinct from simple intermodulation, the two often appear together in high density radio environments. Engineering teams measure this by monitoring the modulation index of a clean carrier while a modulated interferer is applied.
Filtering at the input stage can reduce the power of the interferer before it reaches the nonlinear stages. High dynamic range components are necessary to maintain signal separation.
Component Rating
Specification sheets for amplifiers list the maximum input levels for two-tone tests to provide a baseline for calculating the risk of this distortion. The cross-modulation level is typically expressed in decibels relative to the desired signal. Low distortion is a requirement for co-located radio equipment.