Meaning
Planar metal interconnect structures built in packaging dielectric layers provide the high-density routing paths required for multi-die assemblies. This architecture, known as a dual-damascene rdl, forms both the vertical vias and the horizontal routing lines within a single electrochemical deposition step. The method eliminates the need for separate adhesion and seed layer deposition for each routing level.
It reduces the thermal budget of the build-up process.
Lithographic Definition
Photolithography creates trenches and via holes in a photosensitive polymer dielectric before any metal is deposited. For a dual-damascene rdl, a two-step exposure or a gray-tone mask defines both the deep via cavities and the shallower routing trenches in the same layer. This sequential patterning avoids the interface defects commonly found between separately deposited copper structures.
The resulting cavity profile determines the final metal geometry. Aligning these layers requires high-resolution projection systems to prevent offset errors.
Metallization Strategy
Electrochemical deposition fills the patterned trenches with copper after a barrier layer prevents metal migration into the dielectric. Excess copper is then removed using chemical mechanical planarization to leave a flat coplanar surface. This planarization step allows the stacking of multiple routing levels to build dense interconnect networks.
Stress Tolerance
Interfacial adhesion between the copper traces and the polymer dielectric prevents mechanical failure during temperature cycles. Substrate testing validates that these structures do not delaminate under thermal strain.