Meaning
Electronic interference characterized by a power spectral density that increases as frequency decreases limits the performance of low frequency circuits. Often called 1/f noise, flicker noise arises from the trapping and releasing of charge carriers at the interfaces of semiconductor materials. This phenomenon is relevant in the design of precision sensors and stable frequency sources where low frequency stability is mandatory.
The magnitude of the noise typically scales with the direct current flowing through the device and the quality of the fabrication process. It sets the fundamental noise floor for dc and near dc measurements in integrated circuits.
Spectral Density
Distribution of the noise power follows an inverse relationship with the frequency of operation. In the presence of flicker noise, signal processing at baseband becomes more difficult as the noise power masks the desired signal. Signal processing at a higher frequency using modulation techniques avoids the most polluted part of the spectrum.
This approach shifts the operating point away from the 1/f corner where the noise equals the thermal noise floor.
Semiconductor Impurity
Surface states and lattice defects in the silicon provide the mechanism for charge trapping. Minimizing flicker noise requires careful selection of transistor geometry and processing parameters during the manufacturing phase. Larger gate areas in mosfet devices generally reduce the impact of these fluctuations.
In high precision analog modules, the choice of materials influences the long term stability of the output.
Filter Requirement
Attenuation of low frequency components often requires large capacitor values that are difficult to integrate on a single die. Managing flicker noise in a system often involves digital signal processing to remove the offset drift over time. Since the noise persists at very low frequencies, simple high pass filters might not be sufficient.
Effective mitigation combines hardware design choices with error correction algorithms.