Meaning
Measurement against design target values using time-domain reflectometry verifies that printed circuit board trace geometries match high-frequency signal integrity requirements. Conducted impedance validation measures reflection coefficients along microstrip and stripline transmission lines to identify manufacturing discrepancies in dielectric thickness or copper width. Signal loss and unwanted reflections are minimized when trace impedance falls within standard manufacturing tolerances of plus or minus ten percent.
This verification process applies to physical coupon testing and finished board inspection, stopping at the boundary of component lead interface compliance.
Reflection Analysis
Signal reflections occur wherever trace physical dimensions or dielectric properties change abruptly along high-speed transmission paths. Performing impedance validation with high-resolution test pulses reveals local discontinuities caused by component pads, vias, or glass weave variations. Excess capacitance from solder mask deposition can drop trace impedance by several ohms below predicted nominal values.
Discontinuities degrade eye diagram openings in high-speed digital radio interfaces.
Coupon Testing
Test coupons located on PCB panel borders replicate actual signal trace geometry for non-destructive TDR testing. Standard coupons enable rapid automated pass or fail screening prior to component population.
Layer Stackup
Discrepancies between calculated dielectric constant values and actual cured resin thickness shift trace impedance. Manufacturing adjustments adjust etch factors to compensate for copper weight variations.