Meaning
Internal semiconductor reference voltage fluctuation generates unwanted electrical noise on output power rails in linear power management circuits. Bandgap voltage references, error amplifiers, internal pass transistors, and bias networks contribute thermal and flicker noise across wide frequency spectrums. Low-dropout regulator noise degrades signal purity when supplying sensitive analog blocks, voltage-controlled oscillators, analog-to-digital converters, and phase-locked loops in wireless systems.
High-frequency phase jitter and receiver sensitivity degradation occur when clean supply voltage lines suffer from microvolt-level amplitude variations. The phenomenon spans from sub-hertz 1/f noise frequencies up to megahertz feedback loop bandwidth limits. It excludes external power supply ripple originating from preceding switching regulators or board-level electromagnetic interference coupling.
Spectral Output
Low-frequency flicker noise dominates the spectral power density below one kilohertz, while thermal noise creates a flat noise floor at higher frequencies. Internal bypass capacitors connected to the reference node suppress flicker noise before amplification by the internal error amplifier. Low-dropout regulator noise appears as phase noise sidebands on output radio frequency signals when powering voltage-controlled oscillators.
Transceiver modules require low integral noise density within active channel bandwidths to maintain quadrature amplitude modulation accuracy. Spectral density measurements require specialized low-noise amplifiers and spectrum analyzers during integrated circuit characterization.
Power Integrity
Sensitive smart device sub-assemblies demand high signal-to-noise ratios across modern cellular and satellite frequency bands. Voltage fluctuations on power rails modulate internal RF mixer stages, inducing phase jitter and degraded error vector magnitude performance. Low-dropout regulator noise sets the absolute minimum floor for receiver thermal noise figures in highly integrated radio designs.
Selecting power management components with low microvolt root-mean-square noise figures preserves receiver blocking performance. Power integrity simulation tools model regulator noise figures alongside board power distribution network impedances.
Output Filtering
External passive component selection determines final noise levels presented to sensitive load circuits. Adding low effective series resistance ceramic capacitors creates a high-frequency bypass path that reduces high-frequency voltage noise. Low-dropout regulator noise mitigation requires careful balance between output capacitance values and loop stability margins.
Inadequate output capacitance causes gain peaking in the control loop, elevating noise at the regulator bandwidth boundary.