Meaning
Physical openings in metal enclosures or shielding cans on a circuit board are necessary for thermal venting, trace routing, or component clearance. However, each rf shield can aperture acts as a slot antenna that can leak high-frequency electromagnetic energy. The dimensions of the rf shield can aperture determine the frequency bands that can pass through, with larger openings allowing lower-frequency signals to escape.
Proper shielding design requires careful calculation of these opening dimensions to maintain electromagnetic containment.
Leakage Mechanism
High-frequency currents flowing on the inner surface of the shield can are forced to route around any physical gaps. This displacement of currents creates a voltage difference across the rf shield can aperture, which causes it to radiate noise into the external environment. This leakage can interfere with the device’s own antennas or fail regulatory emission limits.
Design Rule
To prevent electromagnetic leakage, the maximum length of any single opening is kept much smaller than the wavelength of the highest noise frequency. A common design rule limits the rf shield can aperture length to one-twentieth of the target wavelength. Multiple small vias or holes are preferred over a single long slot to maintain both airflow and shielding effectiveness.
Structural Mitigation
Adding internal bulkheads or conductive gaskets can help minimize the leakage from necessary structural gaps. These gaskets seal the rf shield can aperture to ensure continuous conductive contact with the ground plane of the circuit board. This sealing prevents high-frequency noise from escaping and protects sensitive receiver circuits.