Meaning
A design change order alters the physical interconnections within the layers of an integrated circuit substrate or printed circuit board. This process, referred to as a substrate ECO, is initiated when a design error or component obsolescence requires modifying the copper traces or via placements on the bare board. It allows designers to correct design issues without starting a completely new design from scratch.
In high-density ball grid array applications, this change must be carefully managed to prevent timing violations in high-speed transmission lines, ensuring that the redesigned routing matches original impedance and delay targets across all critical signal paths.
Hardware Revision
When a substrate ECO is released, it specifies the exact modifications to be made to the gerber files or substrate masks. These modifications can include rerouting signal lines to avoid crosstalk, adding decoupling capacitors close to power pins, or altering pad sizes to accommodate a new package type.
Implementation Cost
Applying a design change at this stage is costly because it requires remaking the photomasks or fabrication tooling. However, it is often more economical than redesigning the entire system architecture or delay the product launch. The cost depends on the number of layers affected and the complexity of the changes.
Validation Process
The updated layout must undergo thorough design rule checks and simulation runs. The engineering team verifies that the substrate ECO has resolved the original issue without introducing new signal integrity or thermal problems.