Meaning
Spurious frequency components generated by non-linear interactions inside active radio frequency components appear at predictable arithmetic combinations of fundamental signals. A third order mixing product arises when two carrier signals interact within a non-linear amplifier or mixer stage, producing intermodulation signals near original transmission frequencies. Spurious frequencies generated at two times one frequency minus another fall within operational receiver passbands.
Linear transmission behaviors and fundamental signal amplification operate independently of non-linear intermodulation phenomena.
Nonlinear Distortion
Transceiver front-end components exhibit small non-linear responses when driven by high-power input signals. When multi-tone signals pass through a non-linear low-noise amplifier, a third order mixing product forms at intermodulation frequencies corresponding to mathematical combinations of input signals. Power levels of these spurious products increase at three times the rate of input signal power increases.
Radio frequency design engineers run third-order intercept point calculations to predict intermodulation distortion levels.
Spectral Interference
Intermodulation signals falling inside receiver sensitivity bands degrade signal to noise ratios. Occurrence of a third order mixing product masks weak incoming target signals, causing packet loss in cellular receivers.
Front End Filtering
System integration teams evaluate receiver selectivity using multi-tone interference test sequences in RF shielded chambers. Suppressing a third order mixing product requires high linearity low-noise amplifiers and sharp SAW bandpass filters ahead of mixer stages. Receiver compliance testing confirms that intermodulation rejection ratios satisfy cellular standard specifications under maximum input power conditions.
Careful RF layout practices minimize passive intermodulation generated at mechanical connector interfaces.