Meaning
Firmware execution transfer requires a vector table handoff to pass control safely from the bootloader stage to the application layer inside connected hardware. System architects program the processor register holding the exception vector table base address before executing a branch instruction that enters the main runtime environment. Memory boundaries dictate that the relocation offset must align with hardware requirements mandated by the core architecture.
Memory Alignment
Hardware designers enforce strict power-of-two alignment constraints on the relocation base address during the transition phase. Processor exceptions fault immediately if the shifted pointer fails to meet the byte boundary rules defined in the manufacturer specification. Firmware routines calculate this displacement value dynamically when the payload occupies non-volatile flash memory segments outside the zero address space.
Register Sequence
Processor initialization sequences write the relocated vector base address directly into the vector table offset register of the Cortex-M core. Control logic then disables global interrupts momentarily to prevent asynchronous faults during the pointer update procedure. Execution proceeds through a software reset trigger that reads the initial stack pointer value from the newly mapped vector table before jumping to the reset handler routine.
Interface Boundary
Assembly verification testing confirms that the application image responds correctly to hardware interrupts after the transition completes. Debuggers monitor the privilege level transition to verify that execution drops safely from bootloader supervisor mode down to application thread mode. Production programmers store checksum values immediately preceding the vector block to validate image integrity before allowing the handoff sequence to execute in deployed devices.