Meaning
Radio frequency receivers and power amplifiers generate unwanted mixing products when processing multiple carrier frequencies simultaneously. Evaluating a system’s carrier-to-intermodulation ratio quantifies the power level of the desired signal relative to spurious signals created by non-linear device characteristics. Higher values indicate clean signal amplification with minimal spectral regrowth into adjacent channels.
Non-linear junction behavior in components produces third-order and fifth-order intermodulation products that degrade receiver sensitivity. Test procedures measure these relative power levels across specified operating bandwidths and drive levels. Compliance boundaries end where active device saturation dominates passive distortion mechanisms.
Linearity Margin
Active component biasing determines the threshold where harmonic mixing products begin to impair signal integrity. Maintaining a high carrier-to-intermodulation ratio requires operating power amplifiers below their 1 dB compression point. Backing off output drive power reduces intermodulation product levels at a faster rate than carrier power reduction.
Design trade-offs balance power efficiency against intermodulation performance.
Measurement Protocol
Dual-tone RF signals fed into a device under test generate predictable intermodulation sidebands. Assessing carrier-to-intermodulation ratio involves measuring carrier peak power and sideband peak power using a calibrated spectrum analyzer. Automated test software subtracts the peak intermodulation amplitude from carrier amplitude.
Handover documentation includes these sweeps across the operational frequency band.
Distortion Floor
Passive components generate intermodulation products under high RF power levels due to surface oxidation and loose mechanical contact. A degraded carrier-to-intermodulation ratio in passive distributed antenna systems causes severe desensitization of co-located receiver channels.