Meaning
Baseline power metrics representing the internal thermal noise floor of a spectrum analyzer define the weakest input signal detectable across a designated resolution bandwidth. Expressed in decibels referenced to one milliwatt per hertz or at a standardized measurement bandwidth, display average noise level governs instrument sensitivity during spurious emission and low-level harmonic testing. The value ceases to define measurement accuracy when input signal amplitudes approach within ten decibels of this intrinsic floor.
Internal Attenuation
Input attenuator settings directly shift the effective sensitivity ceiling of the receiver. Every ten decibels of added radio frequency attenuation elevates the visible trace baseline by an identical ten decibels, masking microvolt emissions beneath the mixer noise. Activating an internal low-noise preamplifier counteracts high mixer noise figures, depressing the display average noise level toward minus one hundred and sixty-five decibels referenced to one milliwatt per hertz.
Pre-selector filters ahead of the mixer suppress out-of-band energy that could otherwise drive active stages into non-linear compression. Excessive attenuation protects internal mixers from damage during intentional transmitter bursts, yet inadvertently hides marginal out-of-band compliance failures.
Filter Scaling
Resolution bandwidth reduction proportionately drops the integrated thermal noise delivered to the log detector. Decreasing this filter bandwidth by a factor of ten drops the displayed noise line by exactly ten decibels. Video averaging filters then compress the peak-to-peak amplitude fluctuations of the noise baseline without altering its mean power level.
Narrowing sweeps in this manner allows weak spurious tones to emerge visibly above the noise grass during compliance debugging.
Verification Protocol
Instrument calibration procedures establish sensitivity limits before conducting formal unintentional radiator emissions sweeps. Testing laboratories document the display average noise level across the target frequency span using a matched fifty-ohm termination load on the receiver front end. Sweeps must demonstrate sufficient dynamic margin between this internal floor and the regulatory mask limit.
Radiated compliance margins documented in test reports depend fundamentally on holding this internal noise threshold stable across ambient room temperature swings.