Meaning
Microscopic flattening of surface roughness on thread faces and contact shoulders causes a gradual reduction in the initial clamping force of a secured assembly. This permanent deformation, known as embedment relaxation, occurs rapidly within the first hours after a joint is tightened. As the microscopic high points of the metal surfaces flow plastically under high contact pressure, the bolt slightly shortens its stretch.
Such shortening is a primary cause of early-stage tension loss in newly assembled RF shielding enclosures.
Surface Roughness
Finishing methods used on aluminum castings and stamped covers dictate the rate of preload decay. Rougher surfaces present larger peaks that deform more readily under stress. Machined faces experience less leveling and thus less tension loss.
Tightening Strategy
Manufacturing processes can counteract this initial loss through specific torque sequences or assembly intervals. One common approach involves retightening the fasteners after a brief rest period to restore the lost preload. Another method uses a slow tightening speed that allows some plastic flow to occur before the final torque is recorded.
By managing the assembly sequence, factory technicians ensure that the joint retains sufficient tension to maintain seal integrity across the product lifecycle.
Joint Simulation
Engineers estimate the expected tension loss by running cyclic vibration and thermal stress tests. These laboratory trials quantify how much preload is retained after the initial settling period. The measured residual force is then compared to the minimum required to compress the elastomeric conductive gaskets.
If the remaining force falls short, designers must increase either the initial torque or the surface finish quality.