Meaning
Lateral loss of conductor material beneath the protective chemical photoresist mask occurs during wet subtractive processing of printed circuit boards. Chemical etch undercut creates a trapezoidal cross-section across traces instead of an ideal rectangular geometry. Etchant solution attacks exposed copper sidewalls while removing vertical bulk material between traces.
The physical mechanism terminates once panels leave the spray chamber and enter the chemical neutralizer bath.
Geometric Distortion
Sidewall erosion shifts trace geometries from designed rectangles into trapezoids possessing wider bases and narrower top widths. This profile alteration changes the conductor cross-sectional surface area and alters high-frequency electric field distributions. High etch undercut drops characteristic impedance by thinning trace sections across stripline and microstrip geometries.
Controlled impedance routing requires compensation within original computer-aided design files to counter this lateral erosion. Process engineers apply an etch factor, calculated as the ratio of vertical etching depth to lateral undercut loss. Higher etch factors correspond to steeper sidewalls that resemble ideal profiles.
Process Mechanism
Acidic cupric chloride or alkaline solutions spray forcefully across exposed copper panels to break metallic bonds. Etchant naturally seeps beneath photoresist edges because the chemical reaction dissolves copper omnidirectionally. Prolonged chemical contact increases sidewall consumption, worsening the trapezoidal tilt.
Thicker outer copper layers require extended dwell periods in etcher baths, thereby accelerating undercut development. Spray nozzle pressure, copper grain alignment, and etchant fluid temperatures regulate lateral attack velocities.
Fabrication Tolerance
Verification involves destructive microsection analysis of test coupons situated on panel dropouts following etching lines. Automated optical inspection verifies top and bottom trace widths against tolerances established in IPC-6012. Conductor line edge deviations exceeding ten percent from nominal Gerber artwork generate impedance non-compliance, forcing board rejection.
Etching verification sheets track chemical bath specific gravity alongside trace geometry logs. Production panels release to solder mask application only when undercut parameters track inside process capability windows.