Meaning
Spectral distortion occurs when two high-frequency signals interact in a nonlinear system to generate unwanted close-in product frequencies. Receiver designers track IM3 to determine the linearity limits of amplifiers and mixers. These generated frequencies fall directly within the passband of the system and cannot be filtered out.
The measurement becomes irrelevant once the input power drops below the system’s thermal noise floor. Because these spurs reside close to the carriers, they can disrupt adjacent communications.
Nonlinear Distortion
Input power increases cause these distortion products to grow at three times the rate of the fundamental signals. Analyzing IM3 levels helps engineers calculate the third-order intercept point of the amplifier. High distortion degrades the signal-to-noise ratio of adjacent channels.
This degrades wireless performance.
Measurement Method
Two signal generators combine their outputs through a high-isolation power combiner to prevent crosstalk before the device under test. Standard procedures quantify IM3 by measuring the amplitude difference between the fundamental tones and the generated spurious tones. A spectrum analyzer sweeps the narrow band surrounding the inputs.
This capture reveals the distortion footprint.
System Calibration
Cables and combiners can generate their own nonlinear artifacts and distort the result. Engineers must verify that the test setup has an residual intermodulation level well below the performance of the device under test. Applying attenuators before the receiver prevents analyzer mixer saturation.
This step guarantees that the observed distortion originates solely from the tested hardware.