Meaning
Initial energization phases in electrical systems trigger high instantaneous current spikes as uncharged capacitors fill and magnetic cores establish initial flux fields. Managing inrush current prevents false trips in overcurrent protection circuits and eliminates power rail dips during hot-plugging events in cellular gateways. System integrators place NTC thermistors, load switches, or soft-start circuits on input lines to limit peak current amplitudes.
Uncontrolled current transients cause contact welding in relays and premature degradation of power MOSFETs.
Transient Surge
Uncharged input decoupling capacitors present near zero impedance during initial power apply moments.
Mitigation Strategy
Active soft-start controllers slew gate voltages on main input MOSFETs to ramp output rails smoothly. Controlling gate slew rates limits charge current into bulk storage capacitors without generating continuous power dissipation. Passive NTC thermistors offer high initial resistance, absorbing energy before heating up and dropping resistance to low values during steady state operation.
Qualification testing measures peak current spikes using current probes and oscilloscopes during cold startup sequences.
Thermal Limitation
Rapid power cycling undermines passive protection devices because thermistors remain hot and low-resistance during immediate restarts. Dedicated active switch controllers avoid this recovery delay by resetting soft-start timers instantaneously upon voltage loss. Exceeding MOSFET safe operating area curves during soft-start ramps leads to silicon destruction.