Meaning
Digital diagnostic procedures that use boundary scan architecture to verify the connections between integrated circuits without physical test points simulate electronic stimulation across physical signal traces. Implementing virtual interconnect testing allows engineers to verify high-density printed circuit board layouts where physical probes cannot access the small fine-pitch ball grid array solder joints. This method relies on internal shift registers to toggle driver pins and capture states on receiver pins.
Operation Loop
Test vectors are shifted serially through the scan chain input, loaded into output boundary registers, and then clocked across the board traces. In virtual interconnect testing, the receiving chips capture these signals in their inputs and shift the results back out to the test controller for analysis. This continuous loop allows for rapid scanning of hundreds of board interconnects in a few seconds.
Defect Diagnostic
Software algorithms compare the received vectors with the expected patterns to identify shorts, opens, and stuck-at faults on the lines. When virtual interconnect testing reveals a mismatch, the diagnostic software isolates the specific pin combination that is failing. This pinpoint accuracy eliminates the hours spent by technicians with manual oscillo-scopes trying to trace an open trace under a dense component.
Furthermore, the diagnostics can detect faults on resistive pull-up and pull-down networks, helping to find assembly issues that standard electrical probes would miss due to probe pressure.
Interface Requirements
Successful execution requires that the main digital chips on the board support standard boundary scan protocols such as IEEE 1149.1. Adopting virtual interconnect testing also demands that the test access port pins be routed to an external connector for easy coupling with factory test controllers. This design choice pays off by enabling full interface test capability on every board produced.