Meaning
Measurement procedures in wireless engineering require direct coaxial connections between a device under test and an analyzer to bypass the air interface. Utilizing a conducted rf test eliminates environmental reflections and path loss variations that typically affect over the air measurements. This methodology governs transmitter power, receiver sensitivity, frequency stability, and harmonic emission levels within a controlled coaxial medium.
The boundary of its application stops at the antenna port, as any component past this interface demands radiation field analysis.
Circuit Interface
Temporary transmission lines or coaxial switches provide the mechanical link to the RF transceiver board. Integrating a miniature RF switch connector allows the coaxial cable to bypass the onboard antenna during the conducted rf test phase. This connection operates under a matched impedance of fifty ohms to prevent reflections that degrade measurement accuracy.
Signals pass through this physical junction with minimal insertion loss.
Measurement Parameter
Spectral purity represents the primary criterion evaluated during these coaxial sessions. A typical conducted rf test measures the error vector magnitude to verify modulation quality. These figures establish the hardware performance.
Production Integration
High volume assembly lines rely on these direct connections to isolate test failures rapidly. Executing a conducted rf test during board level screening prevents defective assemblies from receiving expensive enclosure shielding. Test fixtures utilize automated spring probes to contact the RF test pads on the circuit board.
Automated software runs the test sequences within several seconds to maintain high manufacturing throughput.