Meaning
Electromagnetic compatibility conducted emissions testing relies on inductive sensing to quantify radio frequency disturbance flowing along power and signal wiring harnesses without severing conductors. A current probe measurement captures these guided common-mode currents across defined frequency spans by clamping a calibrated toroidal transformer around the target cable bundle. The boundary of this technique stops where non-contact inductive coupling encounters shielded conduit that diverts displacement currents directly to chassis ground before the sensor aperture.
Transfer Impedance
Factory calibration data defines the frequency-dependent transimpedance value applied to convert the raw voltage reading off a fifty-ohm spectrum analyser port into amperes of disturbance current. During current probe measurement execution, the insertion impedance of the clamp adds resistance and inductance into the circuit loop, shifting the resonance of long cable assemblies if the fixture exceeds standard design limits. Technicians verify this parameter inside a coaxial calibration jig according to CISPR 16-1-2 procedures prior to recording compliance data.
Cable Placement
Physical location of the clamp along the cable bundle shifts the measured amplitude because high-frequency standing waves create voltage nodes and current peaks at quarter-wavelength intervals. Regulatory test plans specify precise spacing from the equipment under test enclosure connector, typically fifty millimetres or one hundred millimetres, ensuring repeatable capture of maximum common-mode fields. Handover documentation records this separation distance alongside the bundle routing path across the non-conductive bench support.
Compliance Record
Final product qualification requires logging the corrected spectral peaks against statutory limits set by civil or military standards. If an unshielded wire harness passes the radio frequency current ceiling, radiated emissions tests inside the anechoic chamber show a corresponding drop in low-frequency electric field spikes. The laboratory test report binds these conducted current values to the final bill of materials revision and harness layout drawings.