Meaning
Permissible variation in the characteristic impedance of a symmetric trace pair ensures signal integrity in balanced high speed digital lines. This boundary, known as the differential impedance tolerance, is typically specified as a percentage of the nominal target value, often plus or minus ten percent. Maintaining this value prevents reflections that can degrade the eye diagram of a differential receiver.
The limit applies to the trace structure along its entire length from transmitter to receiver pins.
Impedance Variation
Impedance shifts occur when dielectric thickness or copper width departs from the nominal design value. In differential pairs, any differential impedance tolerance mismatch produces common mode energy that increases electromagnetic radiation. Such impedance variations can distort the received signal, causing jitter and timing errors.
These reflections are especially severe when the frequency of the signal has a wavelength comparable to the physical length of the trace variation.
Trace Geometry
Geometric consistency across the circuit board depends heavily on the precision of the manufacturing process. Etch rate variations across the panel modify the trace profile and alter the differential impedance tolerance of the design. Resin rich areas or glass bundles in the dielectric laminate also cause localized impedance changes.
Copper weight and thickness must be monitored continuously during plating to minimize these geometric shifts.
Acceptance Criteria
Quality assurance utilizes time domain reflectometry to verify compliance with the design specification. The test coupon is evaluated to ensure standardized measurement. Units exceeding the specified differential impedance tolerance are rejected.