Meaning
Metallic surface finishes applied to the copper pads of a circuit board provide a barrier against oxidation and a solderable interface. The use of electroless nickel immersion gold is common in high-density interconnect designs where flat pads are required for fine-pitch components. This finish consists of a nickel layer followed by a thin layer of gold.
Chemical Deposition
The process relies on an autocatalytic reaction to plate nickel onto the copper, followed by a displacement reaction for the gold. Unlike electrolytic plating, electroless nickel immersion gold does not require electrical bus bars, allowing for the coating of isolated traces and vias. Strict control of the chemistry in the plating tanks ensures the thickness of the gold remains between two and four micro-inches.
Surface Planarity
Flat topography provided by the coating is a benefit for placing small resistors and ball grid arrays. Using electroless nickel immersion gold prevents the uneven topography often found in hot air solder leveling, which can cause components to tilt or bridge during reflow. The gold layer disappears into the solder joint during assembly, leaving the nickel to form the intermetallic bond.
Corrosion Risk
Excessive phosphorus in the nickel layer or improper gold displacement can lead to a defect known as black pad. This condition weakens the mechanical strength of the joint and may cause electrical opens under stress. Monitoring the immersion rate and bath age is necessary to prevent the nickel from oxidizing before the gold can protect it.