Meaning
Coaxial measurement tips featuring a central signal conductor flanked symmetrically by two reference ground contacts evaluate planar high-frequency interfaces directly on printed circuits. Using a ground-signal-ground probe permits wideband frequency-domain transmission and reflection testing without requiring permanent soldered coaxial test jacks. Dual outer ground contacts establish continuous shielding and tight return loop areas directly adjacent to the contact pitch.
The physical definition stops where single-ended ground-signal or balanced differential probes take over based on alternate contact pad geometries.
Contact Topology
Symmetrical ground points flank the center conductor to terminate electric and magnetic field fringes uniformly. Using a ground-signal-ground probe creates a coplanar transmission path that matches standard fifty-ohm measurement instruments. Balanced outer ground contacts minimize ground loop inductance across open test pads.
The probe pitch, measured center-to-center between contact tips, dictates the high-frequency cutoff boundary. Typical contact spacings span one hundred to five hundred micrometers across precision measurement fixtures. Beryllium-copper or tungsten probe tips maintain mechanical compliance across successive touchdown sequences.
Calibration Procedure
High-frequency measurements require moving the measurement reference plane directly to the probe contact tips. Engineers place probe points onto precision calibration substrates containing alumina or silicon carrier plates. Short-open-load-thru or line-reflect-match calibration sequences remove cable losses and internal probe parasitics across the vector network analyzer.
Calibrated setups reveal true device responses without corporate fixture distortions. Poor calibration contact degrades phase accuracy across frequencies extending past forty gigahertz.
Verification Interface
Touchdown repeatable testing operates under stereoscopic microscopes mounted atop vibration-isolated probe stations. The ground-signal-ground probe addresses landing pads designed on drop-in test coupons or module boundaries during prototyping. Production verification sheets record return loss and insertion loss sweeps over specific operating bands.
Mechanical tip wear alters contact resistance, demanding probe replacement when contact resistance exceeds one ohm. Verified s-parameter files feed directly into design optimization loops for radio frequency front-end tuning.