Meaning
The suppression of unwanted integer multiples of a transmitter’s fundamental frequency is essential for preventing interference in co-located receiver bands. This harmonic emission attenuation must be achieved before the signal reaches the antenna to comply with international electromagnetic compatibility standards. Low-pass filters and band-pass structures are integrated into the RF front-end to block these spurious transmissions while allowing the primary signal to pass with minimal insertion loss.
Filter Selection
Distributed-element microstrip filters or lumped-element ceramic filters provide the necessary rejection at the second and third harmonics. Proper design of the harmonic emission attenuation circuit prevents the amplifier from saturating the input stages of neighboring receivers. The selection between these filter types depends on the available board area and the power handling requirements of the transmitter.
Integration Shielding
High-frequency traces routed on inner layers sandwiched between ground planes maximize physical isolation. Utilizing localized metal shields prevents this electromagnetic bypass, ensuring the harmonic emission attenuation meets the specified system level. Board designers route high-frequency traces on inner layers sandwiched between ground planes to maximize physical isolation.
Regulatory Compliance
Testing labs measure spurious emissions in a radiated and conducted chamber to certify that the device meets FCC or ETSI limits.