Meaning
Spurious electromagnetic signals arise in non-linear active components when two or more transmitter frequencies interact within the same circuit. These intermodulation mixing products can fall directly into adjacent receiver bands, causing desensitization and communication failures. The most severe issues originate from third-order combinations because they lie closest to the original signals.
Spectral Analysis
High-performance spectrum analyzers measure the power level of these unwanted tones relative to the primary carrier signals. In high-power transceivers, the presence of intermodulation mixing products indicates that the power amplifier is operating too close to its saturation point. Engineers track these products during design verification to ensure that the emission levels comply with adjacent channel leakage ratio requirements.
Hardware Mitigation
Passive components like high-rejection filters and isolators reduce the strength of the feedback signals that generate these unwanted frequencies. When designing the front-end module, minimizing intermodulation mixing products requires careful layout of the trace geometry and selection of low-distortion mixers. Linearity-enhancing techniques such as digital pre-distortion in the transmitter path further suppress these spurious signals before they reach the antenna.
These measures are especially critical in environments where close physical proximity of antennas exacerbates the coupling of transmit energy.
System Coexistence
Multiband designs must operate without self-interference when multiple radios transmit simultaneously. Controlling intermodulation mixing products ensures that the harmonics do not bleed into co-located gps or cellular receivers. This precaution is vital for maintaining the throughput of compact multi-radio assemblies.