Meaning
Angular deviation between the actual measurement axis of an optical instrument and its intended theoretical axis introduces systematic coordinates offsets. This line of sight error typically stems from misalignments in the internal optics, encoder runout, or environmental refraction that bends the light path. In laser trackers and total stations, the error increases proportionally with the distance to the target.
Regular compensation routines must run to measure and correct this offset before executing high-precision measurements.
Angular Deviation
Geometric offsets within the rotating axes of a tracker generate predictable pointing errors as the instrument pans and tilts. This angular deviation creates systematic pointing errors that worsen at extreme vertical angles. Two-face measurements, which involve rotating the instrument telescope by one hundred and eighty degrees, isolate and cancel the horizontal and vertical collimation errors.
Software algorithms then apply these measured values to correct the single-face measurements.
Target Centering
Perfect alignment of the optical beam with the physical center of the spherically mounted retroreflector is necessary for sub-millimeter precision. A target centering error occurs when the beam does not strike the apex of the prism, which introduces a distance and angle bias. Modern tracker software employs active quadrant detectors to keep the beam locked on the target center during movement.
This continuous tracking minimizes the dynamic component of the line of sight error.
Calibration Offset
Internal correction parameters stored in the instrument firmware compensate for the residual optical misalignments. This calibration offset is determined during the user-level pointing compensation routine. It remains stable under constant thermal conditions.