Meaning
Printed circuit board structures incorporate laser-drilled blind or buried vias to connect adjacent thin conductive layers across high-density substrates. Constructing a microvia multilayer assembly allows routing density to increase dramatically while reducing parasitic inductance in RF trace routing. Plated microvias provide direct vertical interconnects between component pads and internal ground planes.
Structural integrity depends on copper plating thickness consistency within small via barrels.
Interconnect Density
Tight component placement demands small pad diameters that conventional mechanical drilling cannot produce reliably. Implementing a microvia multilayer assembly enables routing escape paths for scale ball grid array packages with pin pitches under zero point five millimeters. Stacked microvias filled with electroplated copper create robust thermal and electrical vias directly under silicon dies.
Circuit board real estate savings permit smaller enclosure footprints for compact IoT hardware. Laser ablation produces clean via target holes through thin prepreg layers with high dimensional precision.
Thermal Stress
Z-axis thermal expansion differences between laminate resin and electroplated copper induce stress at via target land junctions. Repeated reflow passes can cause microvia multilayer assembly structures to suffer target pad separation if copper plating adhesion is weak. Reliability testing subjects completed board assemblies to continuous thermal shock cycles from minus forty to one hundred twenty-five degrees Celsius.
Void-free copper filling prevents barrel cracking during thermal expansion.
Plating Reliability
Homogeneous copper deposition within microvia barrels ensures consistent electrical resistance. Fabricating a microvia multilayer assembly requires careful bath chemistry control during electroplating steps. Defect-free via filling resists mechanical stress during assembly board flexing.