Meaning
Wireless transmitter designs must respect a lower frequency limit that defines the starting boundary of the wireless local area network spectrum in the super-high frequency band. Transmitting at 5150 MHz represents the entry point of the Unlicensed National Information Infrastructure band. This spectral floor governs the physical layout of internal printed antennas and multi-band radio modules.
Regulatory authorities enforce strict power density limits at this frequency to prevent interference with adjacent satellite services.
Spectrum Allocation
A defined band begins at this specific frequency to allow indoor wireless devices to operate without licensing. Regional bodies allocate the band from 5150 MHz to 5250 MHz under strict power constraints. Transmitters operating in this range must adhere to low-power limits to protect co-primary mobile satellite services from uplink degradation.
Hardware Constraint
Antenna design must account for the high attenuation experienced at the lower edge of this band. The matching network for a wireless module must be tuned to minimize return loss when the transceiver operates near 5150 MHz. Poor impedance matching at this band edge reduces total radiated power and degrades receiver sensitivity.
Designing microstrip patch antennas requires precise dielectric substrate selection to maintain gain across the entire band. In practice, copper trace tolerances on the printed circuit board can shift the resonant frequency, causing the device to fail emissions testing when operating at its lowest channel limit.
Compliance Standard
Certification protocols require specific radiated power measurements to verify that emissions do not bleed into adjacent restricted frequencies. Testing at 5150 MHz is part of the standard transmitter evaluation for FCC or ETSI approval. Designers must submit test reports demonstrating compliant power spectral density and band-edge emissions.
Handover documents for module integration cannot be signed off without these measurements.