Meaning
Requirements for the design and performance of ancillary equipment appear in the technical specifications for electromagnetic interference testing. Compliance with cispr 16-1-2 ensures that line impedance stabilization networks and voltage probes behave consistently across different laboratories. This part of the standard series focuses on the equipment needed to measure conducted emissions on power and signal lines.
The document establishes the limits for parameters such as voltage division factors and phase response.
Impedance Standardization
Maintaining a constant load for the device under test prevents fluctuations in measured noise due to varying power source impedances. The cispr 16-1-2 document specifies a 50 ohm impedance for the measuring port to match standard receivers. Because the utility power grid has a highly variable impedance, the stabilization network provides a defined environment for the emission.
Coupling Network
Safety and signal integrity are managed by the internal components of the line impedance stabilization network defined in cispr 16-1-2. Capacitors block the low frequency power while allowing high frequency noise to pass through to the measurement port. This separation is the primary function of the network during a conducted emissions test sequence.
Frequency Range
Measurements typically span from 9 kHz up to 30 MHz for most commercial applications. Different circuit topologies are required within cispr 16-1-2 to maintain accuracy over this broad spectrum. If the device operates at higher frequencies, the standard provides guidelines for extending the measurement capability.