Meaning
Drilled cylindrical openings through printed circuit boards feature bare laminate walls entirely devoid of conductive metal plating. These openings serve exclusively as mechanical passages for alignment pins, mounting hardware, standoffs or plastic housing retention snaps. The definition covers bare, unmetallized drill penetrations through the board substrate, terminating where conductive barrel plating or electrical interconnect functionality begins.
Fabrication Sequence
Mechanical drilling schedules separate unplated openings from conductive via barrels to protect their non-conductive walls. Fabricators drill all plated through-holes first, passing panels through chemical desmear and copper deposition baths to form conductive barrels. Non-plated through-holes undergo secondary drilling cycles only after all copper plating, etching and solder mask operations reach completion.
Alternatively, fabricators may mask these openings using dry film tenting resist before electroless copper cycles, preventing metal deposition along the internal barrel walls. Secondary drilling eliminates tenting risks but adds a mechanical handling pass that increases fabrication costs. Annular copper rings around these holes must maintain sufficient setback distances to prevent drill wander from tearing into internal metal layers.
Mechanical Functions
Hardware attachment schemes rely on bare hole walls to preserve galvanic isolation across structural mountings. Fastening screws, metal standoffs and chassis mounting posts insert directly through non-plated through-holes to anchor the circuit board into product housings. Because the hole walls contain no exposed copper, conductive fasteners remain insulated from internal circuit planes, eliminating short-circuit pathways.
Tooling pins on automated pick-and-place conveyors also utilize these openings to orient panels during component populating and solder paste printing. Tight drill diameter tolerances are required to keep mechanical mounting points rigid against shock and vibration. Press-fit plastic retention clips depend on precise hole diameters to maintain spring tension without cracking brittle laminate resins.
Clearance Requirements
Internal copper layers must step back from the drill edge to prevent environmental moisture ingress from shorting adjacent power planes. Inner layer copper planes require clearance pull-backs of at least 0.25 mm to 0.50 mm from the non-plated hole wall. Moisture absorption along exposed glass fibers can form conductive anodic filaments if electric fields exist near bare hole edges.
Solder mask clearance rings must expose bare laminate around the hole opening, preventing solder alloy accumulation from altering fastener seat depth during wave or reflow soldering. Fabrication inspection drawings verify these mechanical setbacks to guarantee that assembly fasteners do not crush copper traces or cause layer-to-layer delamination during torque application. Dimensional verification appears on outgoing quality inspection reports.