Meaning
Intermittent extraction of high current from a battery characterizes the power consumption profile of most wireless sensor nodes. During pulse current discharge, the battery must supply rapid bursts of energy to the transmitter without dropping below the minimum system voltage. This discharge mode is common in devices that remain in sleep mode for long periods and wake up only to transmit telemetry.
Operational Impact
Battery chemistry determines how well a cell can handle these transient loads without suffering from permanent capacity loss. Under pulse current discharge conditions, the internal resistance of the cell causes a transient voltage drop that is deeper than the steady state drop. If this drop is too severe, the microcontroller may experience a hard reset, terminating the transmission before completion.
Hardware Limitation
Selecting the appropriate cell requires examining both the continuous and pulse current ratings provided in the datasheet. When the pulse current discharge requirements of the radio exceed the capability of the selected cell, engineers must add parallel capacitors to supply the peak energy. This hardware addition increases the bill of materials cost but is necessary to prevent premature battery depletion or device failure.
System Optimization
Designing the firmware to minimize the duration of the transmit pulse reduces the overall stress on the power source. Modifying the transmit power and data rate helps control the magnitude of the pulse current discharge. This optimization ensures that the energy consumed per transmission is minimized, which in turn allows the battery to operate efficiently and extends the overall deployment lifetime of the device.
Additionally, utilizing low power listen modes instead of continuous scanning can further reduce the frequency of these high current demands.