Meaning
Concave spherical contour machined into the entry face of an injection mould sprue bushing interfaces directly with the convex nozzle tip of the machine barrel. Standardized under international tooling formats, sprue bushing spherical radius dimensions govern sealing geometry, preventing high-pressure melt leakage while transferring resin into the runner system. The parameter governs entry orifice diameter, spherical seat depth and contact surface curvature, ending its boundary at the transitional taper entering the primary sprue feed channel.
Sealing Principles
Contact geometry relies on deliberate curvature mismatch between nozzle tip and sprue seat. Machine nozzle tips are ground to a slightly smaller radius than the sprue bushing spherical radius, typically using a half-inch nozzle against a five-eighths-inch bushing seat. This differential produces a ring contact seal at the inner aperture under machine carriage thrust, rather than broad surface contact.
Pure ring contact produces localized pressure that seals against plastic injection pressures exceeding two thousand bar.
Melt Delivery
Mismatched radii prevent nozzle freeze-off caused by excessive heat transfer into the water-cooled sprue bushing. Correct seating alignment maintains a continuous transition from the nozzle bore into the sprue aperture, preventing resin dead spots. Reverse radius matching causes molten plastic to pack behind the contact ring, generating stubborn drool and nozzle leaks.
Correct orifice alignment suppresses cold slug formation that could clog gates or produce surface blemishes in finished parts.
Inspection Procedure
Blue-dye contact checks verify that the seating ring forms a continuous circular band immediately surrounding the central sprue orifice without gaps. Coordinate measuring instruments or radius gauges check seat accuracy against tooling drawing requirements prior to press installation. Hardness testing confirms the contact face reaches 50 to 55 HRC, preventing indentation from repeated machine carriage forward docking force.
Assembly checklists record machine nozzle compatibility before hanging the mould on the production floor. Damaged seating faces require immediate remachining to prevent resin blow-by behind the locating ring. Carriage forward force must be matched to seat area to prevent permanent crushing of the spherical radius.
Maintenance handovers log nozzle tip contact profiles to guide replacement cycles. Proper sealing preserves calculated hydraulic pressure inside the runner system. Thermal camera checks during cycling verify absence of localized cooling around the nozzle-to-seat interface.
Production logs record absence of drool build-up around the locating ring pocket.